Is there a bad taxidermy community?
thenewred
joined 1 year ago
They were asking for a ride. She speaks Ukrainian. I'm guessing she wasn't bothered by it.
I might have crossed my wires, it was probably just a forum post I misread. I happened to have new ceramic burrs so I went ahead and installed them.
I got closer to a perfect pull this morning after adjusting the right lever! Unfortunately I'm out of that coffee now so the process restarts with the next bag.
New ceramic burrs.
I typically use light roast beans, apparently ceramic is better there.
Went through the hyperalignment procedure and got close but not perfect. Had to move on and get it back together at some point.
Works the same, just inline. And this grinder has two
I don't know about best, but these have been decent
Slurping Turtle (Easton)
Wild Ginger (Hilliard)
Aki Hana (Henderson)
Me writing my resume in third person
A blessing! Free credit monitoring! All is well
Free solo*
But with a harness full of gear for extra weight reasons
And gloves because less grip == good?
Me, spending hours on Age of Empires 2 and loving it
We water by soaking the plants in the tub, then letting them sit on towels before going back on the shelf. A bit tedious but only has to be done every 1-2 months.
1190
Everything I need is still in in the old settings windows that haven't changed in 23 years
(lemmy.world)
I don't know why I even bother opening the settings app
Pretty happy with how this turned out, even months later
It's wild how similar woodworking and 3d printing are.
- Get a 3d printer
- Print things for the 3d printer
With woodworking
- Get a table saw
- Make things for the table saw
Now I can mix and match
Model: https://www.printables.com/model/205258-featherboard-with-replaceable-heads-m6
Designed this storage solution for belts
https://www.printables.com/model/519768-belt-organizer-hanger-6-or-8-belts
Had minimal clearance between these overhead shelves and the garage door, and the perfect light spacing was a few inches away from the cross bars. So I designed these snap fit brackets to offset the lights inline.
The lights make a huge difference, much more pleasant to work in the garage.
What I learned:
- there is some sag because the screws aren't at the top of the bracket. I would add a tab that protrudes on the side so I could add a screw higher.
- the screw face split on layer lines on a few of these. Still works but not perfect, so I would make the screw face thicker.
Also printed cable management clips
view more: next ›
What is this used for?