I have no idea if this is a clever bypass around expensive commercial offerings, a clever waste of time that barely improves over doing it by hand, or somewhere in between, but it sure looks like a nice design and print.
this post was submitted on 04 Oct 2024
189 points (99.0% liked)
3DPrinting
15759 readers
98 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
It's an automation step for a small scale factory
Yeah, definite neato factor but by eyeball at least I feel like I could do that bend by hand within a mm tolerance of this. Hard to imagine this precision is needed. Makes sense if mass producing these I guess.
This is a workshop for combat FPV drones, so precision is extremely important.
Interesting. Important for balancing? Or does the signal reception really depend on that much precision? I'm Suprised to learn that either way.
They have to operate at very long distances in an electronic-warfare saturated environment. Even the tiniest imperfections can be the difference between life and death.
And in this case you want death!
Dunno how to feel.... Excited because it looks cool or sad that it will be used to kill someone. The world has gotten depressing
I make a lot of stuff and I don't think I could bend it that precisely by hand. Also I would take much much longer.
I think the black thing they show at the end is the usual tool to do it, this just looks like 20 extra needless steps.
It's for bulk building drones you have into the faces of occupiers, good enough is necessary perfect is not.
What am I looking at here? What are these antennae used for?
They're popular with drone pilots, here's some old school website about them
I'm not a radio guy, but for a drone antennae, wouldn't you want vertical range rather than broadside range?
Here's the only thing you need to know: radio is black magic.
A drone operator usually is not standing directly under the drone, so no. Or alternately, the drone if probably further away from you horizontally than vertically during most of its operation.
One interesting thing here is that, for a given altitude, the antenna gain will be higher the further away the drone is.
No, yagi directionals point at the drone broadside.
Do these come flat packed is that what the tool is for or do you form the whole thing first then use the tool to bend?
Looks like stamped or laser cut pieces that then need bending in the 3rd dimension.
Then soldering a coaxial connector or wire to each half to finish them.
These look like the little flying sensor balls from Twister.
it it for sharing or just showing off?