188
submitted 1 week ago by cm0002@toast.ooo to c/linux@programming.dev
you are viewing a single comment's thread
view the rest of the comments
[-] mojofrododojo@lemmy.world 2 points 1 week ago* (last edited 1 week ago)

interesting, worked in cad/cam and arch viz but never ran into it called mcad. always specific applications like catia or autocad, onshape etc.. assumed it was an application name

[-] bitfucker@programming.dev 3 points 1 week ago

Because if I say CAD then it would include KiCAD which is rock solid already and IMHO is perfect for most SME too

[-] chonglibloodsport@lemmy.world 2 points 1 week ago

There’s also ECAD software for electronics. I believe a lot of product teams use both ECAD and MCAD. The former for designing the circuit board, the latter for designing the case and any moving parts.

this post was submitted on 14 May 2026
188 points (100.0% liked)

Linux

13744 readers
179 users here now

A community for everything relating to the GNU/Linux operating system (except the memes!)

Also, check out:

Original icon base courtesy of lewing@isc.tamu.edu and The GIMP

founded 2 years ago
MODERATORS