I've just finished getting my laptop set up the way I like it, including maximising the RAM and upgrading the screen. I opened it up to use it, and the screws on the hinge tore through the plastic.
To top it off, the plastic on the bottom of the laptop, the side that's been removed here, has also broken.
My wife definitely didn't drop the laptop while she was tidying up though...
EDIT: Apologies all, I'm having trouble with Lemmy today, and it's not letting me reply.
I'll try to reply tomorrow, but in the meantime;
It's a Stonebook branded Clevo n751BU, a 7th gen i5. It's held up respectably well until it appears to have been knocked in the corner where the hinge is. The plastics on both sides of the hinge have given out.
I've ordered a replacement base, but the palm rest which is pictured is not available anywhere that I can find. I'm going to dismantle the hinge to clean and oil it, then reassemble it slightly less tightly, and epoxy the screws into place. The reason for taking it apart in the first place was to add a third hard drive. It has an nvme drive, and I had two HDDs going spare that can hold my documents and music. They're being synced now as I was having problems doing it remotely, but once they're in they can be managed with Syncthing. The laptop shouldn't need to come apart agin afterwards :)
I've been building and repairing computers and laptops for about 30 years, so I'm comfortable with completely stripping it, and can use it as an excuse to give everything a clean again. Short of replacing these HDDs with SSDs, there's nothing else that can physically be upgraded, so I'm half tempted to glue it shut so that I don't get tempted again :D
Yep, it's the mounting point here. As someone pointed out below, the insert that holds the screw has ripped out of the plastic. The base of the laptop was already broken, so put extra pressure on this part.
I'm going to strip everything out and epoxy the inserts back in place, then epoxy over the bottom part of the hinge once the screws are in. The laptop should never need to be opened again, so a bit of overkill won't hurt here.
I'm going to try to loosen the hinge slightly too, but it looks like a pin design rather than a screw, so it might just be a case of cleaning and lubing it instead.