curled

joined 11 months ago
[–] [email protected] 10 points 2 months ago* (last edited 2 months ago)
[–] [email protected] 32 points 4 months ago* (last edited 4 months ago) (1 children)
  • touch the tip of the solder where the iron meets the pad or the pin

  • try to get as much contact with both the pad as the pin as you can

  • the pad could be dirty or not hot enough. Especially when the pad is connected to a ground or power plane layer in the PCB it may take longer than expected to reach a sufficient temperature. Usually adding some flux helps remove any dirt.

[–] [email protected] 13 points 4 months ago

Thanks for the update and your hard work!

[–] [email protected] 5 points 9 months ago (1 children)

Did something change? Last time I bought an album on Qobuz i could download the whole thing in a single zip file. This was quite a while ago though

[–] [email protected] 6 points 11 months ago

Similar setup here, as a bonus I also connected my jellyfin to Listenbrainz to get recommendations and some sweet stats.