curled
joined 11 months ago
-
touch the tip of the solder where the iron meets the pad or the pin
-
try to get as much contact with both the pad as the pin as you can
-
the pad could be dirty or not hot enough. Especially when the pad is connected to a ground or power plane layer in the PCB it may take longer than expected to reach a sufficient temperature. Usually adding some flux helps remove any dirt.
Thanks for the update and your hard work!
Did something change? Last time I bought an album on Qobuz i could download the whole thing in a single zip file. This was quite a while ago though
Similar setup here, as a bonus I also connected my jellyfin to Listenbrainz to get recommendations and some sweet stats.