Giannis_Dor

joined 11 months ago
[–] [email protected] 1 points 9 months ago

is it worth getting that secondary ap the ac mesh or should i just downgrade the lr to the plus

minght also get the lr and fidle around the the power settings

 

so i want to install a better wifi system at my parents house and i cant choose between the 2 aps get a u6 plus at 110 or get a u6 LR at (140 only 30 up currently at a sale from 180 to 140)

im going to also get an unifi ac mesh 100 for outdoor coverage but im conteplating if i realy need that extra coverage and streams the lr gives

walls are brick are around 10-13cm

isp is 50/5 its possible for upto 200/20 or a 1gig in the future

there are 4 rooms : parents,sisters my room and bathroom. and 3 areas will be close to the internal ap with no walls inbetween. Another area that i want to cover is the balcony/garden

i want it to be a 2 ap setup 1 wifi 6 ap for indoors will be at the living room/diner table kitchen

parents bedroom is the first wall my room is 2 walls from the indoor and 1 wall from the outdoor ap some for my sister ony differce is see has 3 walls from indoor ap anf 1 wall from outdoor

is it worth it getting the u6 LR over the u6 plus just for that extra range and extra streams?

the ac mesh for now will be wired via powerline or mesh if speeds are better powerline is about 40-60mbps. In 2 or 3 months ill run extirior rated cat 6 for that ac mesh

[–] [email protected] 1 points 9 months ago

that's why I got my mikrotik hap ax2 in the first place

 

so I wanted run a cable from the front of the house to the back front of the house is living room and back is my room and balcony it's going to go from the front to my room on a switch then from a switch to an externally placed ubiquiti AC mesh what should I look for when buying an outdoor rated cable? I want to get cat 6 for now it will be a gigabit link I want it to be future proof so upto like 10gig the run will be around 20-30 meters long it will be exposed to the sun

should I get a shielded cable or a dual shielded cable? can you suggest good grounded ethernet patch ports?

also I've worked with utp cables before they where cat 5e but does cat 6 have the same thickness for its conductor's? do I need to get cat 6 rated rj45 terminals?

[–] [email protected] 1 points 10 months ago

21700 can go to 5000mah

[–] [email protected] 1 points 10 months ago

it's does have a low voltage disconnect cause it's the BMS job to protect the battery and circuit