Originally posted by u/748aef305 at 2025-01-28T01:14:15Z
As the title says, I finally like my PPA-CF(aka the artist formally known SirayaTech PAHT-CF apparently???) print settings!
Granted these are a bit on the extreme of settings (0.12 layer lines... Wait... What layers? Lmao) instead of 0.16, but truth be told, (and sadly, or not so sadly depending on your outlook, for some other Bambu owners) what I feel did the biggest difference hands down was doing the "Poor Man's X1E mod" where you add a 33Ohm (NOT kOhm!!!) resistor in line with your thermistor so that temps above 280ish are drastically higher. For reference my printer was printing this at what it "thought" was "only" 293C, But IRL it was basically printed at a 318-320C actual nozzle temp.
The max "stock" 300C setting with this gets you roughly around 340-354C IRL, which means I can't WAIT for Polymaker to have their 3kg rolls of PPS-CF available for order to test! Open to suggestions of what to print with it first btw!
If anyone is interested in this mod or futther settings (they're largely stock other than the temp/cooling, or lack thereof) or anything else, please feel free to hmu however you see fit.
And as always, keep up the good work fellow fosscad-ers!
Source: https://a.thumbs.redditmedia.com/sxL7yJ-XE_HOjeLDMILfSqx6anUmUv6DIz8egsv2fD8.jpg
