Woodworking

6151 readers

21 users here now

A handmade home for woodworkers and admirers of woodworkers. Our community icon is a planter box made by @Captain Aggravated, the winner of our summer '24 woodworking contest. Congratulations!

founded 1 year ago

MODERATORS

[email protected]

Does anyone have a trick for this problem with self-driving screws? (lemmy.ca)

submitted 3 months ago* (last edited 3 months ago) by [email protected] to c/[email protected]

13 comments fedilink hide all child comments

Situation: using a screw gun to drive in the self-driving screws (the star shaped ones) horizontally, and sometimes at a difficult angle above my head. Hard to get good leverage like that. The driver starts spinning the screw but it doesn’t catch right away and then the screw jumps out and falls on the ground.

Has this happened to you? Is there a trick for that?

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 13 points 3 months ago

Get yourself a bit holder with a guide sleeve (https://www.dewalt.com/product/dwairdg/ir-drive-guide-w-2-impact-ready-bits). Works for any type of screw since you load it with whatever bit type you need for your screw (in your case, torx). If you've never seen one, you'll love how easy it makes driving screws when they wanna fall off the bit/work.

Only real drawback is you don't have precise control of the angle the screw starts at but it's close enough for most work.