MeatballFlag

joined 1 year ago
[–] [email protected] 3 points 1 year ago (1 children)

As per usual, the fine becomes simply the cost of doing business

[–] [email protected] 2 points 1 year ago

I was having the same audio delay issues with speech, take-off/landing sounds, etc when I was playing the game installed on an HDD storage array. I moved the install to the SSD system drive and that's all gone away. Crashes have gone down too, I was crashing 2-3 times in an evening of playing but for the past several days or more I might see one crash in a 4+ hour session. Still more crashing than it should but it's not absolutely terrible

[–] [email protected] 2 points 1 year ago (1 children)

Cars don't cease to function when driven in areas with little to no cell reception...

[–] [email protected] 4 points 1 year ago (3 children)

Because some areas have poor to no cell reception

[–] [email protected] 5 points 1 year ago

I wish I'd known about or considered this a few years ago. I would have kept my now 20 year old car instead of trading it in for a new model.

This world we live in sucks...

[–] [email protected] 17 points 1 year ago (1 children)

I'm sure this will about as effective as D. A. R. E. in American schools and keeping people off drugs

[–] [email protected] 3 points 1 year ago (1 children)

Maybe because I didn't know what I was doing back then but that was the only way I used Limewire

[–] [email protected] 3 points 1 year ago (2 children)

Fucking studfinders man...

[–] [email protected] 1 points 1 year ago

I hate the ea launcher with such a burning passion as to outshine the sun. ~80% it causes a problem launching a game for me and provides zero benefits for it's use. It has no consumer friendly reason to exist

[–] [email protected] 2 points 1 year ago (1 children)

Thanks I'll give some of these suggestions a try. I am printing with PLA at the same temps I've used in the past with the same material. I wouldn't think the change to pei would require a changing of print temp but I'll keep that in mind as well.

 

This print started fine the first handful of layers before I walked away. I came back later and everyone of these blocks was curling up with the corners lifting off the bed. I just put on the PEI plate, this is the first print on it. I did level the print bed manually with a sheet of paper, the first layers of each block looked nice and uniform. I'm printing with the bed at 60c which is what I've always used with the flexible magnetic print mat that came on the printer. Should I be turning down the bed temp with the PEI plate?

Thanks for any advice

[–] [email protected] 4 points 1 year ago (4 children)

Rather than setting up a VPS like some of you is there a reason I couldn't run this on my existing home unraid server?

view more: next ›