this post was submitted on 26 Jul 2024
24 points (100.0% liked)

datahoarder

6715 readers
25 users here now

Who are we?

We are digital librarians. Among us are represented the various reasons to keep data -- legal requirements, competitive requirements, uncertainty of permanence of cloud services, distaste for transmitting your data externally (e.g. government or corporate espionage), cultural and familial archivists, internet collapse preppers, and people who do it themselves so they're sure it's done right. Everyone has their reasons for curating the data they have decided to keep (either forever or For A Damn Long Time). Along the way we have sought out like-minded individuals to exchange strategies, war stories, and cautionary tales of failures.

We are one. We are legion. And we're trying really hard not to forget.

-- 5-4-3-2-1-bang from this thread

founded 4 years ago
MODERATORS
 

Running GParted gives me an error that says

fsyncing/closing dev/sdb: input/output error

Using Gnome Disk Utility under the assessment section it says

Disk is OK, one bad sector

Clicking to format it to EXT4 I'm getting a message that says

Error formatting volume

Error wiping device: Failed to probe the device 'dev/SDB' (udisks-error-quark, 0)

Running sudo smartctl -a /dev/SDB I get a few messages that all say

... SCSI error badly formed scsi parameters


In terms of the physical side I've swapped out the SATA data and power cable with the same results.


Any suggestions?

Amazon has a decent return policy so I'm not incredibly concerned but if I can avoid that hassle it would nice.

top 4 comments
sorted by: hot top controversial new old
[–] [email protected] 22 points 3 months ago

If an HDD doesn't work in every conceivable way out of the box it must be an RMA. These devices are too delicate to settle for anything less than flawless on arrival.

[–] [email protected] 8 points 3 months ago

I would return it, but if you are curious you can try some of the following to get experiencing identifying bad disks.

You could try a different computer or controller to be sure.

If you can get some writes/reads to work, you can use badblocks or dm-crypt: https://wiki.archlinux.org/title/Badblocks#Alternatives

Badblocks will write known data to disk then read it to verify its good. If the disk is malicious, this can be faked. badblocks is also a little slow.

Using dm-crypt in the wiki will write zeros through dm-crypt which will result in random noise being written to disk, then compare with zeros to verify reads are good. This can not be faked easily since the zero stream is encrypted as it is written to disk.

[–] [email protected] 2 points 3 months ago

Ive never had an HD arrive DOA, but one amazon new drive i ordered did that.

It was frustrating to diagnose cause that was the last thing I believed could be wrong.

[–] [email protected] 2 points 3 months ago* (last edited 3 months ago)

if it's functioning unexpectedly there should be signs it's failing in the SMART data.