9
Suggestion for mounting ServoMotor on the door for Automatic Door Unlock with ESPHome on ESP32 (lemmy.world)
submitted 1 year ago* (last edited 1 year ago) by [email protected] to c/[email protected]
1 comments fedilink hide all child comments

Hello Lemmings, Hope you guys are doing well.

Objective: Open the door automatically through HomeAssistant

My Plan:

  1. Use an ESP32 and flash ESPhome. Wire up Servo Motor (SG90) with ESP32. Tie a thread on between the Servo Motor Arm and the physical latch (physical latch that I can pull to unlock the door) such that when the servo motor turns from -100 to +100, the latch is being pulled to cause the door to be unlocked.

  2. I am planning to power this using AA Cells + DC DC Boost convertor.

Issue:

  1. How do I mount the Servo Motor on the door?
  2. Is there any other (read better) way to achieve the same result?
  3. Would you recommend any power source other than AA Cells?

Image for reference:

The latch has a keychain-like loop where the thread is tied. To unlock the door manually, I pull the latch towards right (---->) . This action is planned to be automated by Servo Motor.

all 3 comments
sorted by: hot top new old
[-] [email protected] 1 points 1 year ago

Personally I love sho-goo. It holds great. And is also removable if needed. (Twist hard and it will come off then you can peel the stuff off). Stays flexible when cured and just use tape to get it to stay while curing

this post was submitted on 18 Apr 2024
9 points (100.0% liked)

Ask Electronics

3753 readers
24 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 2 years ago
MODERATORS
[email protected]
[email protected]