this post was submitted on 01 Feb 2024
29 points (89.2% liked)

Trees

6700 readers
17 users here now

A community centered around cannabis.

In the spirit of making Trees a welcoming and uplifting place for everyone, please follow our Commandments.

  1. Be Cool.
  2. I'm not kidding. Be nice to each other.
  3. Avoid low-effort posts

founded 1 year ago
MODERATORS
[email protected]
[email protected]
[email protected]
[email protected]
29
Looking for a new dry herb (midwest.social)
submitted 9 months ago by [email protected] to c/[email protected]
33 comments fedilink hide all child comments
 

I have a pax3 that is starting to show it's age. The battery is not holding it's charge that well and I'm sure the tech has improved a lot over the years. I was looking at a crafty or mighty+ but wanted to see if there was something else comparable for a little cheaper. I would like to keep it under 300, but can spend some more if it's worth it.

you are viewing a single comment's thread
view the rest of the comments
[โ€“] [email protected] 1 points 9 months ago (1 children)

Yeah DIY seems to be the way to go when it comes to IH. I have a tad of soldering experience but it seems like there are a lot of kits that are solderless.

[โ€“] [email protected] 1 points 9 months ago* (last edited 9 months ago)

Good luck with whatever you decide to do :) That board I linked is also solderless from what I understand, the terminal connector with two clamps is for input dc power, the terminal connector with three clamps is for the coil. The two ends of the coil go on the two far ends leaving the middle one empty. In theory should just be able to screw in the coil in one side and pump 12v 10a to the other (hopefully!)