this post was submitted on 11 Jul 2023
46 points (100.0% liked)

Ask Electronics

3316 readers
2 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.


founded 1 year ago
MODERATORS
 

Circuit is for controlling the fan on a Raspberry Pi, just on/off according to temp, no PWM. Not sure about the diode as it has a .7V drop and it's a tiny brushless DC motor. No markings on the fan so I measured the current with a multimeter when hooking it up to a USB charger. Circuit was adapted from here using what I have on hand.

Suggestions? Any advice is greatly appreciated!

*EDIT: Confirmed, this circuit works on a Raspberry Pi 4. Base was wired to GPIO 17 and manually tested using commands:

raspi-gpio set 17 op dh

raspi-gpio set 17 op dl

I didn't use a breadboard, just hack-n-slash with the wires coming out of the fan, the leads on the thru hole components, a jumper connected to gpio 17 as a socket for the base/resistor lead, and heat shrink tubing for insulation. Folded it up as I closed the housing. Case combo including heatsinks and fan here.

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 3 points 1 year ago (1 children)

The board is built into the motor and should also add flyback protection, that's why I'm not sure if I need the diode. Give it juice and it spins.

[–] [email protected] 2 points 1 year ago (2 children)

The point of the diode is to prevent reverse current that gets induced when a (brushed) motor is turned off. It essentially turns into a small generator while spinning down, and the diode essentially short circuits that. It prevents damage to the rest of the circuit. If that motor is brushless (with an integrated control board), you likely won't need it but it doesn't do any harm either.

[–] [email protected] 2 points 1 year ago

It essentially turns into a small generator while spinning down

Kind of like an inductor?

[–] [email protected] 2 points 1 year ago

That's what I figured as well, there's some sort of board under the top of the housing. I'm going to leave the diode in.

I appreciate the advice!