Just finished installing it this evening. Going to update the firmware, run thermal model, and PID tune tomorrow. Also installed the silicone bed mod and need to level everything out. Got a busy day tomorrow, wish me luck.
this post was submitted on 18 Dec 2023
72 points (98.6% liked)
3DPrinting
15763 readers
37 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Assuming my experience is everyones, you will like it. Don’t spend too much time on the thermal model, though. If you get it to work, great! If you don’t, there’s no shame in just turning it off.
Apparently the 3.13 fw supports the Revo now, so we'll see.
Update: Flashed the 3.13.2 Revo fw and new fw isn't working for TM calibration... going through the troubleshooting steps on github
Update 2: got it working with suggestions on the github. Had to manually send some codes to the printer through octoprint to get a TM set up.