So today was coffee station deep clean day including descaling my coffee maker.
After running the descaling solution through the coffee maker, I wanted to soak the shower head in the solution since it was pretty hard hit with scale and the brief contact with the solution while brewing wasn’t enough to clean it up.
So I dumped the hot descaling solution in a stainless steel bowl with the shower heat and left it to soak.
When I came back to check on it (30-60 minutes) everywhere the bowl was in contact with solution was purple. When I touched the purple tint it turned black (I really regret not having taken a photo at this point). It turned out the purple was just residue but the black underneath was (etched?) into the bowl.
I tried scrubbing with dish soap and water, which helped a bit but the bowl was still dulled and dark where it had been in contact with the solution. I then hit it was barkeepers friend which left me with what you see in the photo.
I guess my question is “what the heck happened?”. My best guess is that the bowl is not actually stainless steel and the solution ate off whatever was giving the bowl its shine? The shower head is also stainless steel and it was unaffected in this way. In fact the solution did successfully remove most of the scale build up on it.
Thoughts?
HCl is death for stainless, even 316. I’d avoid putting it directly into a 304 or 316 reactor, even when titrating, since there will be transient high-concentration zones until it all mixes together.
But every mix is a little different. The standard test is to make your reaction / buffer mixture, stir it with a small square of stainless (accurately weighed) in a glass reactor at a few tens of degrees hotter and maybe 3x as long as you intend to run the real thing, and see if the bit of stainless loses mass. More than a mg or two and you’ve got a compatibility problem.
Especially if you’re doing cell culture. Not sure how much nickel and chromium your cells can handle but I’m guessing they might not be happy.