spoiler
For people that don't know this is not how you use Calipers
this post was submitted on 22 Aug 2023
1304 points (99.4% liked)
Memes
45587 readers
1295 users here now
Rules:
- Be civil and nice.
- Try not to excessively repost, as a rule of thumb, wait at least 2 months to do it if you have to.
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Isn't strong or weak mean where the cut needs to be on the line? Since the blade is usually 1/8", weak means that the cut is made before the line, removing the thickness of the blade on the measurement (1 1/2" becomes 1 3/8") and strong means that the cut is made after the line, leaving the actual measurement. This is how I was thought, but I am not in the construction industry.
Depends on the crews tolerances? I've used + or - to refer to 16ths and only call out 1/8ths. 1 1/2" would be "One and four" 1 7/16ths would be "One and three plus"
In old timey boat building they denoted feet°inches°eighths°plus so 58 5/16ths would get written as 4°10°2+