Should I replumb my condensate drain line? (lemm.ee)

submitted 2 weeks ago by [email protected] to c/[email protected]

3 comments fedilink hide all child comments

My condensate drain line is clogged, and there's nowhere for me to access it to clear it out without seemingly removing the evaporator coil (which I'm not doing). The drain does go into a pump.

My main concern is the u-bend is at the top of the drain line, but my understanding from plumbing is that it should be at the bottom to let gravity help with moving water through the trap.

My thought was to use clear corrugated tubing from the drain pan to about a foot above the pump, then adding the bend, then a tee right after with a threaded plug that I can remove to snake the line if needed. I just wanted a sanity check before I started cutting. I can definitely ditch the clear tubing, I just thought it would help identify a clog location in the future.

you are viewing a single comment's thread
view the rest of the comments

[-] [email protected] 2 points 2 weeks ago

The issue ended up being a clogged pump. The condensate couldn't drain into the pump because the pump was full, so it overflowed. I managed to get it running again, but at one point there was smoke in the tank, so I'll have to replace it.

But, the PVC drain line goes straight into the pump, and there's not enough flex in the line to pull it out of the pump. When I replace the pump I'll have to cut the pipe, so I'll install a tee like you suggested. It'll be after the trap, but I should be able to snake it in the future.

this post was submitted on 31 May 2025

7 points (100.0% liked)

Requests for help or general HVAC commentary from outside the trade

74 readers

2 users here now

This is intended to be a group for homeowners and end users to ask hvac related questions.

founded 2 years ago

MODERATORS

[email protected]