submitted 1 month ago* (last edited 1 month ago) by [email protected] to c/[email protected]

24 comments fedilink hide all child comments

So I have my AC connected to a smart plug and I'm trying to figure out what would be the best way to go about automating it.

Currently, I have it set to run every hour on the hour for 20 minutes if the time is between noon and 8 p.m. Which covers the hottest part of the day.

However, what I could do is have it run every other hour instead and have a couple of night runs along with the daytime runs.

Doing it that way would eliminate most of the 16-hour period currently that exists between the ending of one day and the beginning of the next.

Edit: Also, is there an easy way to automate every other hour using the time pattern or would I manually have to set up triggers for 2am, 4am, 6am, 8am, 10am, etc. using the fixed values?

Edit 2: looks like i can use "/2" to accomplish that

you are viewing a single comment's thread
view the rest of the comments

[-] [email protected] 1 points 1 month ago

I can't do that. Without doing it myself, the compressor will absolutely never turn off. Unless I manually flip the switch. There was another commenter below that said that it wasn't a problem as long as you didn't try to start it up again too quickly and I don't so that's all right

[-] [email protected] 3 points 1 month ago

I’ve never seen a window AC with mechanical knobs not cycle the compressor when it hits the temperature set by its thermostat. The fan might run 24/7 but the compressor? How could it possibly regulate temperature otherwise?

[-] [email protected] 2 points 1 month ago

Oh duh, I totally forgot about that. There is a knob to regulate the temperature, and that will kick the compressor off. Currently I just have it set to as cold as it will get and then cut power to the unit itself with the plug. It stays off for a good 40 minutes at a time, which is plenty of time to drain the pressure properly before starting up again.

this post was submitted on 18 May 2025

19 points (95.2% liked)

homeassistant

14912 readers

101 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @[email protected]

founded 2 years ago

MODERATORS

[email protected]