19
Stringing/Oozing Problem
(lemmy.ml)
I am using an Ender 3 Pro v2, and I have followed multiple guides (they all say the same things) for setting up a print to prevent stringing. I’ve also switched between two filaments (Creality and Amolen) and the stringing doesn’t change at all. I have noticed that when heating up the horned, the filament just oozes out like ectoplasm even before the print starts.
I have never had this problem before, and could use some human advice.
I have upgraded/replaced the following parts in the past:
- Bowden Tubes
- Printer Nozzles
- Dual Gear Extruder
- Heater Block
- Heater Cartridge
- Thermistor Temp Sensor
My Tweaked Settings:
What temperature range is the filament rated for, and at what temperature are you printing at?
Oozing is a fact of life. But it's a lot less of a problem at lower temperatures. Also how old is the filament? Has it been sitting out absorbing humidity? Wet filament will drool a lot too.