19
If you had $1500 to spend
(lemmy.world)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 02 May 2025
19 points (95.2% liked)
3DPrinting
18561 readers
96 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
I replied to another post with a list of mods, so take a look at the other comments in the post for some out of box mods.
As a 350 owner, be aware of two things.
First, big bed = big chamber = heat soak takes a while and you have a lot more surface area to lose heat from. If you want to print big ABS/ASA parts you're going to want ACM panels, a better sealed/insulated front door, and potentially a radiant layer inside the printer.
Second, the big printer limits your rate of acceleration some compared to a smaller CoreXY. IMO if you have a big printer to print big things you're probably not going to have small/finely detailed parts that often. Those are the kinds of parts that will go a touch slower. But honestly 5k acceleration is orders of magnitude faster than most bed slingers can achieve and 10-15k is only a 2-3x increase so you're not giving up that much.
Other than than, no regrets about the 350.
So I was looking on West3D and found the kit I wanted, but they are out of stock. They also did not have it in 350x350. I'm guessing the only other option is to purchase everything individually rather than a kit.
I would send them an email. Depending on which kit you're talking about they could probably figure something out or give you an ETA.