submitted 3 months ago by [email protected] to c/[email protected]

43 comments fedilink hide all child comments

Anyone try to build a bed occupancy sensor integrated with Home Assistant? I've looked into load sensors but all of them seem to have pretty small weight limits (low enough to where I don't think it would even support the empty bed).

What devices/sensors have you used for this? And what does your setup look like?

you are viewing a single comment's thread
view the rest of the comments

[-] [email protected] 1 points 3 months ago

I believe that's how most people do it. It works for me. You can also put two in parallel or just add a resistor across the leads to divide the resistance to make it more sensitive. If you used a potentiometer it would make it easier to adjust to hit the exact threshold.

this post was submitted on 17 Mar 2025

27 points (93.5% liked)

homeassistant

14952 readers

1 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @[email protected]

founded 2 years ago

MODERATORS

[email protected]