this post was submitted on 27 Jan 2025
39 points (95.3% liked)
Asklemmy
44615 readers
921 users here now
A loosely moderated place to ask open-ended questions
Search asklemmy ๐
If your post meets the following criteria, it's welcome here!
- Open-ended question
- Not offensive: at this point, we do not have the bandwidth to moderate overtly political discussions. Assume best intent and be excellent to each other.
- Not regarding using or support for Lemmy: context, see the list of support communities and tools for finding communities below
- Not ad nauseam inducing: please make sure it is a question that would be new to most members
- An actual topic of discussion
Looking for support?
Looking for a community?
- Lemmyverse: community search
- sub.rehab: maps old subreddits to fediverse options, marks official as such
- [email protected]: a community for finding communities
~Icon~ ~by~ ~@Double_[email protected]~
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I carry a Fisher Space Pen everywhere, but I switched its cartridge for Pilot Hi-Tec-C refills. It takes a little fiddling to get the refill in there, but once it's in it works great!
I'm not familiar with the pilot refill, what about that swap do you enjoy?
Pilot Hi-Tec-C is a gel pen with refills that happen to fit in the Space Pen. It puts down a crisp, fine line.
The problem with the stock Space Pen is that it's a messy ballpoint. I might be getting worse-than-typical results due to being left handed, but in general I find ballpoints don't write crisp lines, and the ink smudges on my hand much more than gel pens do. But with the gel swap I do lose the feature of being able to write upside-down.
I'll have to try it out! I currently use fisher space pens, and while the pen is reliable, I definitely notice that it's not guaranteed to write evenly.
Was there any hacks you had to do to fit the refill?
Yes; first pull the black plastic piece out of the end of the refill. I read that there needs to be a little airflow into the refill for ink to flow, and when the back of the refill is jammed into the pen that can cut off airflow so you might cut a little notch in the end of the refill where the black plastic piece was. I also sometimes trim about 4mm off the end of the refill, or put a tiny bit of wadded paper in the pen for spacing. But I do this a little differently every time I put a new refill in.
Thank you kindly!