Shelly devices not discovered (lemmy.world)

submitted 5 months ago by [email protected] to c/[email protected]

11 comments fedilink hide all child comments

Hi all! I have a HA server in my LAN and all my IoT devices are in a separate VLAN. In this way to insert all the devices I have to configure them all manually using MQTT commands. Since I'm fed up about this method, I've added a second NIC to the HA VM (Proxmox) that is in the IoT VLAN. When I enter the terminal I see that HA has 2 IPs, one for each network and I thought that all the Shelly (they use the same MQTT broker that uses HA, they're not configured for cloud connection and ColoT is enabled) devices would appear in HA, but...they don't. How do you think that I can troubleshoot this problem?

you are viewing a single comment's thread
view the rest of the comments

[-] [email protected] 1 points 5 months ago

If you’re using OPNsense I recommend you install and enable Avahi to help route discovery traffic, and I would double check multicast is functioning on your wifi.

IIRC with home assistant there are some commands you can run to make it aware of your VLANs.. have a look at this

this post was submitted on 05 Jan 2025

17 points (100.0% liked)

homeassistant

14952 readers

1 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @[email protected]

founded 2 years ago

MODERATORS

[email protected]