The filament came out during a print and I don't know what layer it came out at. I've spent a lot of filament on this print, so is there any way to continue it?
this post was submitted on 06 Nov 2024
33 points (97.1% liked)
3DPrinting
15591 readers
145 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Do you have a pair of calipers that you can use to measure print height? If yes, don't take it off the bed. Measure the height of the print, delete those layers out of the gcode (it's just a text document after all), and reset. Note that the gcode and printer setup might require some fiddling to get right, but I've resumed prints like this without problems before. They don't all look perfect at this layer, but they're certain better than nothing. Once the print loses its hold on the bed, all bets are off.
depending on where in the layer it failed, this could cause more problems. It'll try to print the layer from the start it may get messing (especially if you're missing perimeters, or printing over partial-layer perimters.)
The other issue is that homing may be slightly off; that would depend on the printer. (most are okay, but you might find a visible layer shift in the seam,)
Agree that the result won't be a perfect print, but I personally prefer this route over printing the other half, sanding the first half flat to account for a partial layer like you said, and then gluing.
I guess it comes down to what you goal is. 90% of my prints are functional and I don't really care if they're a bit ugly at times.