The filament came out during a print and I don't know what layer it came out at. I've spent a lot of filament on this print, so is there any way to continue it?
this post was submitted on 06 Nov 2024
33 points (97.1% liked)
3DPrinting
15591 readers
145 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I suppose you could take it off the bed, measure very precisely the height, print just the remainder (by altering the model and re-slicing) on the bed, and glue it to what's already printed. It would almost definitely still have a visible seam and aside from that, I can't think of a way to save it.
Thanks, I'll probably just try to restart in that case.
this is what i was thinking.
most slicers will let you just move the model down in negative z, saving the need to cut or alter the model. (it then slices only the mesh that's on or above the plate.)