3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
Ok new symptom: the corners of a box that I'm printing are curling up
I had this happen on my ender 3 v2 recently as well, a thin layer of washable purple gluestick has solved it for me (though parts are now sometimes a bit difficult to remove and sometimes require a moist rag to get the gluestick residue off)
I've heard of using gluestick...but dang it sounds messy. Do you have a link to the stuff you tried?
Most brands should work fine. Same with hairspray.
I've been using glass print surfaces and glue stick for 10+ years. I just wash off the glass with warm water every 2-3 prints otherwise just add a new layer of glue stick before printing. I'm going to try a G10 print surface next as I finally found some in my country.
Any brand will work. I dont like glue, but its easy to apply and also clean it with water. Glue can fix huge problems like uneven bed, wrong temp etc. You are facing common 3D printing problems. Not sticking to the bed and curling. It can be frustrating, get some patience and you will sort it out.
You did major upgrades, so tunning is hard to avoid. Do PID tuning for your hotend, your temps might be not stable. Check your hotend mount for play. Make sure your part cooling fan is off on the first layer. More squish, higher temp and low speed are your friends. Try with 205/60 C and 10-15 mm/s. Check your retraction, you might have oozing that can cause not sticking at first. If you are printing tiny parts like 5 mm circles on first layer you need to have crazy dialed printer to print that consistently. Still possible of course, but even then some issues at start /end of extrusion can occur. 0.24 mm first layer height is much easier to print than 0.15, simmilar thing with nozzle size. Your filament might be shit, better filaments are more forgiving.
Print 1 layer square and take a picture. Lines must fuse and surface shouldnt be rough when touching it. If you didnt print 100 squares dont give up yet 😉
Edit: any PVA glue stick (the one that is used by kids in school to glue paper)
For issues with corners curling I either use a brim, or if a brim is not good for that model, I add a 1-2 layer circle at that corner in like tinkercad.