Asklemmy

43852 readers

666 users here now

A loosely moderated place to ask open-ended questions

Search asklemmy 🔍

If your post meets the following criteria, it's welcome here!

Open-ended question
Not offensive: at this point, we do not have the bandwidth to moderate overtly political discussions. Assume best intent and be excellent to each other.
Not regarding using or support for Lemmy: context, see the list of support communities and tools for finding communities below
Not ad nauseam inducing: please make sure it is a question that would be new to most members
An actual topic of discussion

Looking for support?

Looking for a community?

Lemmyverse: community search
sub.rehab: maps old subreddits to fediverse options, marks official as such
[email protected]: a community for finding communities

~Icon~ ~by~ ~@Double_[email protected]~

founded 5 years ago

MODERATORS

[email protected]

210

What is something people you encounter at your job say that makes you want to scream? (Job, person & quote) (lemmings.world)

submitted 3 months ago* (last edited 3 months ago) by [email protected] to c/[email protected]

290 comments fedilink hide all child comments

Job: cashier

Item doesn't scan

Customer: "That means it's free, right?"

🙄🙄🙄🙄🙄

Only about 4 weeks in as a cashier and I've heard this enough to last me a lifetime.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 2 points 3 months ago

Ironically just repaired my samsung dryer. Two drum felt gaskets, and the belt since it was disassembled. Front gasket failed and tore out. After examining all components, the torque of belt drive pulls on one side of drum, this puts extra pressure one one set of the drum rollers (Rh side). The rear one is near the hot air duct so it gets more extreme working conditions. bearing has worn shaft slightly and plastic wheel was partially fatigued, so looks like that rollet was dragging and so belt pulls down more front of drum pinching seal from extended weight and torque. The paint was worn off the housings in this section so felt gasket had more friction in that zone. The rear roller near the heating generator duct is a bad design. especially since it hangs off the back housing which is quite flexible in that area. Thankfully the repair was simple, other than completr disassembly , but not convinced it will last long.