From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
For context, LDAC is one of the few wireless audio codecs stamped Hi-Res by the Japan Audio Society and its encoder is open source since Android 8, so you can see just how long Windows is sleeping on this. I'm excited about the incoming next gen called LC3plus, my next pair is definitely gonna have that.
I'd love to say the same but on my Lenovo laptop I get frequent disconnects with bluetooth earphones on Linux alone. Apparently it's a firmware problem with the AX200 board, but even after having updated the firmware and following all the online fixes I still have the problem.
My whole use case for my laptop is getting away from my desk when I want to read something and listen to music at the end of the day, but it's annoying to have to reconnect the earphones every 10 or so minutes. Like everything Linux, it's incredible as long as you have supported hardware and you don't bump into some weird edge case.
I definitely love it for the "it just works" (or rather, you have full control to make it work) factor!
I'm not familiar with the latest in BT audio, but isn't the standard still sub-par in that it has very limited overall frequency bandwidth, resulting in deep sacrifices to fidelity?
I recall a detailed analysis of different BT audio codecs a while back, and the spectrum analysis always showed relatively high noise floor and frequency roll-off (hi-cut/low-cut) within the threshold of human hearing (though admittedly close to the limits). Also, I recall (and this could just be the 2016 tech I am familiar with) that overall bandwidth was limited in that if you played something with low frequency tones, the upper frequencies were dropped, or vice versa. I used to confirm this by using a flat EQ setting, then boosting any range, and you could easily detect the loss of frequency response in the adjacent or distant ranges.
Is this a thing of the past now?
No, soundguys made an anlysis. LDAC is still worse than direct contact and just makes some other sacrifices than aptX.
It is worse than uncompressed, but 990Kbps LDAC is the closest codec to totally transparent I've heard for Bluetooth audio. AptX HD is nearly as good to my ears, and is better than 660Kbps LDAC. The differences are very small though, especially when compared with the differences on the analog side, e.g. the amp, and particularly the headphone design.
Apple side-steps the problem by, at least when you're listening to Apple Music, simply sending the AAC stream as-is to the headphones and has them decode the audio. I don't know why that isn't a more common approach.
I'm still somewhat bemused that we're talking about Bluetooth codecs at all. It surely can't be that difficult technically to get 1.5Mbps actual throughput on Bluetooth and simply send raw 16-bit/44.1Khz PCM. 2.4Ghz WiFi is capable of hundreds of times that speed. Bluetooth has been stuck at the same speeds for decades.