this post was submitted on 22 Feb 2024
103 points (96.4% liked)
Home Improvement
9086 readers
3 users here now
Home Improvement
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I would not. 6cm is about 2 1/2 inches and I would not rely on a wall framed any less thick than 4-by (3.5 inches). Thinner means more flexion which will lead to problems of your plaster cracking and cabinet flushness issues. In terms of strength, it's probably okay, assuming you have fastened that framing solidly.
The trick to finding your studs is to pre-mark your plaster board and keep transferring those marks outward up to the point of hanging your cabinets.
Hi thanks!
Can I just install more 6x6 cm frames and make it more stable in the area I want to hang something or would that not help?
In general, I can hang plasterboard on 6x6 though right?
No. Beam deflection goes as the inverse 4th power of beam thickness in the direction of bending. Adding more material lateral to the direction of bending does not help.
Yes, you can certainly hang plasterboard on that.
My english isn't that good I think I can't follow.
The beam in that room is holding a top floor and roof and should hold way more. The wall that the beam is sitting on is about 35 cm thick.
Der Poster ueber dir sprach allgemein uber dir Berechnung der Durchbiegung von Balken, hier die 60x60mm Kanthoelzer.
Er meint damit also, dass es nichts bringt, weitere Lattungen anzubringen?
Mein Plan ist aktuell:
Küchenanbieter anschreiben und Monteur der Küche ob die Lattungen so in Ordnung sind. Die angebrachte Lattung markieren, sodass der Monteur später dann die Hängeschränke an den Rigips & Lattung schrauben kann und nicht ins "leere" trifft.