I recently upgraded to a Snapmaker U1, though I think other modern printers have this feature as well. I was just printing a plate with multiple objects on it. Specifically I was printing a big squarish body of a tank, a few small pieces, and the tank cannon which was tall and skinny.

Mid-print, the cannon fell over - which was my own fault for not adding supports to it. The printer detected the print failure and stopped it, but that's not the cool part. It allowed me to remove the object from the plate and continue printing the remaining objects! I figured I would have had to start the whole thing over again - wasting a ton of filament on the half completed tank body. Was super impressed!

you are viewing a single comment's thread
view the rest of the comments
[–] 3 points 21 hours ago (13 children)

Just bought a U1 and havent had to use the feature yet but wish I'd had it on my old printer

  • source
  • hideshow 13 child comments
  • [–] 5 points 19 hours ago (10 children)

    It's a software feature, so you can set it up on any printer you can throw klipper at.

    I have it for my Ender 3 pro.

  • source
  • parent
  • hideshow 10 child comments
  • [–] 2 points 9 hours ago (3 children)

    Does the printer head need have pressure advance? I assume that’s how it detects printing over air (and must ignore bridges and overhangs).

  • source
  • parent
  • hideshow 3 child comments
  • [–] 2 points 9 hours ago (2 children)

    I meant aborting certain, but not all parts. Error detection works with cameras, afaik.

  • source
  • parent
  • hideshow 2 child comments
  • [–] 3 points 18 hours ago (5 children)

    Does it work on Bambu printers?

  • source
  • parent
  • hideshow 5 child comments
  • [–] 4 points 15 hours ago (2 children)

    Probably not, but idk. That's what happens when you buy a closed-down system.

  • source
  • parent
  • hideshow 2 child comments
  • [–] [S] 2 points 21 hours ago (1 child)

    I know, right? I'd never heard anyone even mention it before, but it was a life saver!

  • source
  • parent
  • hideshow 1 child comment
  • [–] 3 points 21 hours ago

    I think people don't even think about it anymore because it has been there for a few years now. My old cheap bedslinger has it too, not the automatic fault detection (because it doesn't have a camera) but exclude by object has been a part of mainline klipper for 4-5 years now.

  • source
  • parent