27
Devices continuously dropping off my ZigBee network (lemm.ee)
submitted 6 days ago by [email protected] to c/[email protected]
31 comments fedilink hide all child comments

I recently setup my ZigBee network in Home Assistant, using a Conbee III with deConz on my Synology NAS.

I purchased a few Aqara Temperature sensors and a couple of Mini Switches.

I was able to get them to pair just fine, but they won't remain online for more than a couple days. They then drop off and I can't even reconnect them easily. I need to try to pair them again like 10 times before they come back online.

At this point I don't know if the problem is my network, the Conbee III, deConz, or the Aqara devices.

I don't know much about ZigBee, but a couple things that I tried so far were:

  1. Use a USB extender instead of connecting the Conbee III directly to my NAS.
  2. Bring the devices as close a possible to the gateway. I don't have a big home, so I don't think distance is a factor here, but still, I put of the sensors right next to the gateway, and it would still drop after a while.

Do you have any hints on things to try to get this fixed, or at least identify the problem?

you are viewing a single comment's thread
view the rest of the comments
[-] [email protected] 9 points 6 days ago

Having moved my home assistant from the middle of my house to a garden shed/office, check your WiFi network is not on channel 1. As that will most likely be the same part of the spectrum as your ZigBee network, if you have your ZigBee on channel 11.

[-] [email protected] 9 points 6 days ago

On another note. A zigbee network is a mesh network set up at pairing. Moving your host around will not re-generate the routes in the network and make your devices drop.

Pair your devices (and hub) in there position they will be in when installed.

[-] [email protected] 3 points 6 days ago

Also: mains powered devices (lightbulbs, smart plugs, zigbee repeaters) will all act as a repeater in your mesh. Depending on your home it might help to add in a few of them. But keep in mind that this will not magically make your existing devices use them. When setting up your network always pair your permanent powered devices first so they can act as endpoints for your battery powered ones.

load more comments (2 replies)
load more comments (8 replies)
this post was submitted on 01 Jun 2025
27 points (100.0% liked)

homeassistant

14645 readers
2 users here now

Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io

founded 2 years ago
MODERATORS
[email protected]
[email protected]