I've been getting some problem layers with this filament, especially on flat pieces like this. The first layer is always good, but flat layers (top and bottom) that are not on the bed are not great, like the filament is sagging and not connecting to the lines next to it, regardless of if they are supported or not. This one was a flat layer (completely horizontal) that was fully supported with the zigzag supports from the sovol version of cura.
I know ideally I wouldn't have totally flat overhangs like this but with the piece I want to print there isn't really a way around that other than printing multiple flat parts and gluing them together.
I am using a Sovol sv06 and overture PLA. I did not have this issue with the sovol silk silver pla.
I've tried leveling my bed again and I think mu z offset is OK because the first layers look good. Currently I'm printing another temp tower and will try some other calibration pieces but any help is appreciated
I’ve had best results with Cura, trees, support interface on using “grid” with “0.8mm interface thickness” and “75% interface density”, and when printing with 0.2 layer thickness and 0.1 gap between support and model (which then snaps to the 0.2 layer thickness)
I've tried tree supports when printing miniatures - I'll start messing with them for other stuff too. Thanks for the tips. I'll try those settings