633
Anon reflects on e-sports (sh.itjust.works)
submitted 2 years ago by [M] to c/greentext@sh.itjust.works
146 comments fedilink hide all child comments
 
you are viewing a single comment's thread
view the rest of the comments
[–] 15 points 2 years ago (5 children)

I’ll defend this guy: there can easily be a harmonic at half the flyback frequency that is audible. It’s lower amplitude so less loud, but I could believe someone being able to hear that.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 5 child comments
    •
  • [–] -4 points 2 years ago* (last edited 2 years ago) (4 children)

    Yes, as I previously stated, if there is a problem with the flyback transformer circuit, it is possible that the frequency or volume of the noise it generates can become increased or different.

    Though again, PC monitors never made an audible noise unless they were low quality and used the cheaper 15.7kHz transformer in their construction.

    Other noises associated with CRTs are the degaussing noise, which only happens once usually after turning on the CRT or after pressing the degauss button, or the sound of old IDE hard disks spinning, which also make a constant high frequency noise.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 4 child comments
    •
  • [–] 7 points 2 years ago* (3 children)

    Not sure you follow: even if the primary frequency is out of range, a harmonic (half the frequency, quarter the frequency, etc) can simultaneously exist with the primary.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 3 child comments
    •
  • [–] -5 points 2 years ago (2 children)

    I suppose its possible with a low quality CRT that has poor construction, leaving loose parts or thin plastic fins that can vibrate at harmonics of a lower frequency, but high quality CRTs don't have this issue.

    Extra or louder noise does not occur in normal operation of a correctly functioning flyback transformer circuit. Any frequency or harmonic (vibration) that occurs that is not the specified frequency of operation of the flyback transformer is caused by a problem in the circuit. A brand new CRT with known good parts will not have any kind of extra harmonic.

    I had to replace a flyback transformer because it was too loud, and it was a pretty simple job. Hardest part was finding a new flyback transformer. After replacement, the noise volume was reduced to normal levels.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 1 point 1 year ago

    Look, I know what I heard. And that was every old school screen I’ve ever encountered. What I don’t know is harmonic or flyback transformers.

    Maybe maybe it’s a ntsc vs pal thing? I’ll restate, I don’t know anything about the tech but I could tell if a screen was on.

    And before you restate that they were low quality: maybe every screen I’ve ever encountered was shit, yea. But then shit was the default apparently.

  • permalink
  • fedilink
  • source
  • parent