9
Hubs and dual levels - recommendations? (aussie.zone)
submitted 11 months ago by to c/homeautomation@lemmy.world
3 comments fedilink hide all child comments
 

We're running a mix of zigbee/matter as the network's been building out, but we're needing to expand both into the subfloor and basement brewery. Looking at possibly needing a hub to extend the signal (yay 60's brick and lead paint), anyone have any recs for Australia? I'm looking chiefly at Dialed In and while Tuya have several models they've rather shat the bed for me with their practises so eyeing off alternates.

all 3 comments

sorted by: hot top controversial new old
[–] [S] 2 points 11 months ago*

should add: We will be using this for integrating the clipsal WISER and some smart buttons / leak sensors as well as potentially rolling in some brewpi automation. HA integration as always

  • permalink
  • fedilink
  • source
    •
    [–] 2 points 11 months ago (1 child)

    In my house, I put the hub near the stairwell, and have devices that can be repeaters nearby on each floor. This helps with terrible signal from my copper ceilings and plaster walls.

  • permalink
  • fedilink
  • source
  • hideshow 2 child comments
    •
  • [–] [S] 2 points 11 months ago* (last edited 11 months ago)

    There's no interior staircase from the main house to the basement / subfloor, and the rack is in my office on the opposite side of the house to the brewery but I was considering using cheap RH/temp sensors to repeat the signal through. Which would take care of the sub floor, but still gonna need a hub in the basement brewery as that's going whole hog.

  • permalink
  • fedilink
  • source
  • parent