65
How do I fix this issue with my bed? (lemmy.world)
submitted 3 years ago* (last edited 3 years ago) by to c/3dprinting@lemmy.world
16 comments fedilink hide all child comments
 

I'm running the bed that came with my Ender 3 pro (using a pei sheet, this is repeatable with glass too), been having this issue for a while I think. Is it time to replace the bed?

Update: Figured it out, what my bl touch was attached to was very loose, and was going up on the far side of the x gantry. and it's now fine.

you are viewing a single comment's thread
view the rest of the comments
[–] 2 points 3 years ago

I'd get a good tempered glass sheet, creality sells good ones cheap. it'll go right on top of this. You might use a bit of thermal paste to seal those gaps and make sure it heats evenly. One side of the glass will be textured, I prefer the smooth side.

  • permalink
  • fedilink
  • source
  • parent