65
How do I fix this issue with my bed? (lemmy.world)
submitted 3 years ago* (last edited 3 years ago) by to c/3dprinting@lemmy.world
16 comments fedilink hide all child comments
 

I'm running the bed that came with my Ender 3 pro (using a pei sheet, this is repeatable with glass too), been having this issue for a while I think. Is it time to replace the bed?

Update: Figured it out, what my bl touch was attached to was very loose, and was going up on the far side of the x gantry. and it's now fine.

you are viewing a single comment's thread
view the rest of the comments
[–] 5 points 3 years ago (1 child)

Make sure there isn't too much tension on the cables to the hotend assembly. Could be pulling too tight and lifting a bit when it gets too the far side

  • permalink
  • fedilink
  • source
  • hideshow 2 child comments
    •