20
Issues with PS1 optical drive installation (thelemmy.club)
submitted 11 hours ago by to c/retrogaming@lemmy.world
7 comments fedilink hide all child comments
 

I'm trying to get to the screws under the spindle cap, but they're stuck under it, so I was wondering if getting rid of these screws highlighted would help me to get to those screws

you are viewing a single comment's thread
view the rest of the comments
[–] 10 points 11 hours ago* (2 children)

Looking at your photo, rotate the spindle about 1/8th of a turn anticlockwise until the cutouts in the spindle cap align with the screws?

  • permalink
  • fedilink
  • source
  • hideshow 4 child comments
    •
  • [–] [S] 1 point 7 hours ago (1 child)

    They’re covered up by that more reflective piece of plastic. I can align the cutouts perfectly but they’re blocked by that more glossy part that I can’t move.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] [S] 1 point 7 hours ago (2 children)

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 4 child comments
    •
  • [–] 1 point 4 hours ago

    It should be able to slide/rotate on top of the rubber base. It was assembled like that, with the spindle notches lining up with the holes in the base. So something has moved in the meantime to take them out of alignment.

    A moderate amount of force might be needed. Eg the amount you can apply with your fingers by holding the top piece with one hand and pushing with the fingers of the other hand on the rubber base to rotate it.

    You shouldn't need to grab it with tools / pliers to move it. If you think you need tools, it's better to stop and have a bit more of a think about it before going further.

  • permalink
  • fedilink
  • source
  • parent
  • [–] 1 point 6 hours ago* (last edited 3 hours ago)

    Just turn it until the notch aligned with the screw, then unscrew the screw while pressing in slightly on the side of the notch.

    Edit: That second picture in your original post shows the notches aligned with the screws, so it should be that way. You could take a playing card and try to slip it between the two see if there is anything binding it.

  • permalink
  • fedilink
  • source
  • parent