12
Display issue (lemmy.world)
submitted 2 years ago by to c/buildapc@lemmy.world
30 comments fedilink hide all child comments
 

I finished building my PC recently. when I turn on the monitor when the computer isn't on, there's obviously no signal and I see the bouncing logo, but when the computer is on, it says that there is no signal, and that my monitor is going into standby mode, and the display turns off. my gpu seems to be working fine, and I reseated my ram. What should I do?

you are viewing a single comment's thread
view the rest of the comments
[–] 3 points 2 years ago (1 child)

If you can't hear anything does your motherboard have a display? Did it come with a little speaker? Look in your motherboards manual for the best way to get error signals.

Did you give your computer at least 5 min powered on though?

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] [S] 1 point 2 years ago (1 child)

    No i didn't, but my monitor shuts off every time it's connected to my computer so I can't wait that long

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 1 point 2 years ago* (last edited 2 years ago) (1 child)

    Your monitor doesn't matter just let the computer run for a few minutes then turn the monitor back on

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] [S] 1 point 2 years ago (1 child)

    Oh that's great, I'll see if it works

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] 1 point 2 years ago (1 child)

    Did that happen to work for you?

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •
  • [–] [S] 1 point 2 years ago (1 child)

    No, still have no display and apparently have no boot device which is weird since I wrote fedora onto my usb drive

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 2 child comments
    •