31
Need help removing triangles in PrusaSlicer (lemmy.world)
submitted 3 years ago by to c/3dprinting@lemmy.world
18 comments fedilink hide all child comments
 

Hey y'all. I am trying to do a max perimeter style print, and want to know how to remove these smaller sections. I know I could reduce wall count until I remove them, however that isnt dynamic, and leaves larger gaps than I want in other areas. Is there a setting in PrusaSlicer im missing? I messed around with a few but they didnt give me the results I was looking for.

you are viewing a single comment's thread
view the rest of the comments
[–] 2 points 3 years ago* (last edited 3 years ago) (1 child)

If you’re finding you’re printer is shaking too much, consider adjusting the acceleration/jerk settings

it’ll slow prints down- the maximum axcel/jerk will limit the top speed for the very short moves, longer moves remain mostly unaffected- but it will improve print quality.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 1 child comment
    •
  • [–] [S] 3 points 3 years ago

    I probably should adjust the acceleration settings. In this instance, Im just trying to optimize the print to cut down on print time. There's about 15 or so of these needlessly small sections per layer, so culling them would cut down the print time a bit.

  • permalink
  • fedilink
  • source
  • parent