55
Anyone got ideas on how to fix this bulging issue with thin prints? (thelemmy.club)
submitted 2 days ago by to c/3dprinting@lemmy.world
25 comments fedilink hide all child comments
 

Hello netizens of Lemmy, while printing this single wall wing segment i ran into a problem with significant bulging around the middle. This causes the segments to not fit onto the frame or each other. If anyone has ideas on how to fix this, please share. At this point i'm pretty desperate and willing to try just about anything.

you are viewing a single comment's thread
view the rest of the comments
[–] [S] 2 points 2 days ago (2 children)

Thanks, but unfortunately i only have a 0.2 nozzle. Solid walls beyond 0.5mm in thickness border on impractical for an airplane anyway. I had success printing walls as thin as 0.15mm, but that only works with at least a little bit of infill, if i have to make it heavier i would rather just do that.

  • permalink
  • fedilink
  • source
  • parent
  • hideshow 4 child comments
    •
  • [–] 3 points 2 days ago

    impractical for an airplane

    Depending on how much effort you're willing to put in, I would suggest switching material.

    Use fiber reinforced plastic.

    The process can be done at home, though you may need some practice. You can print the shape you want with a thicker wall thickness and then use that as a negative. You get the best results if you have a compressor and can use vaccum techniques to get the excess plastic out of the material. This will put you in the thickness space you want, and it will still work, and you don't have warping problems.

  • permalink
  • fedilink
  • source
  • parent