That's what I started on (well, a knock off clone) and I still say it's a great printer if you want to learn 3D printing.

Now, if you want to actually print right after buying, no no no. Not a good fit.

It's basically a set of parts that can be cheaply replaced, but measured properly (mostly) and lets you avoid putting together a BOM. Plus, there are tons of them out there, so lots of community support and many cheap, occasionally working, 3rd party upgrades.

I feel like it taught me the mindset of FDM troubleshooting and how the parts/variables interacted with each other. It was $150 a few years ago, so it's great for screwing up and figuring out what you want in your first real printer. It also has a lot of potential and folks that have modded them to actually run well, so it helped me figure out where I fell on the "It just works" to "Let's test these 200 different hotend fan duct designs" spectrum and which features were most important to me.