▲ 66 ▼ Any ideas why the top roof warped like it did? (thelemmy.club) submitted 3 months ago by mortalic@lemmy.world to c/3dprinting@lemmy.world 15 comments fedilink hide all child comments For whatever reason, the top piece warped despite what appear to be basically perfect supports.
[–] floquant@lemmy.dbzer0.com 8 points 3 months ago* (last edited 3 months ago) (1 child) Excessive cooling maybe? Or the support gap is too tall? Edit: might also be nozzle temp too low permalink fedilink source hideshow 2 child comments replies: [–] mortalic@lemmy.world [S] 1 point 3 months ago I took the default prusa slicer snug setting. Though I will check tomorrow to see what else might be set. I remember when reading up on organic supports that there were some suggested changes to support settings. Maybe I changed something... I don't think so though. permalink fedilink source parent
[–] mortalic@lemmy.world [S] 1 point 3 months ago I took the default prusa slicer snug setting. Though I will check tomorrow to see what else might be set. I remember when reading up on organic supports that there were some suggested changes to support settings. Maybe I changed something... I don't think so though. permalink fedilink source parent
