10
Any tips for printing 85A TPU on bambulab A1? (lemmy.world)
submitted 10 months ago* (last edited 10 months ago) by to c/3dprinting@lemmy.world
15 comments fedilink hide all child comments
 

So I have a bambulab A1 and recently wanted to print something with TPU. The issue I have however is that the extrusion is just hella inconsistent. I get a coupel seconds of normal extrusion and then a couple seconds of pretty much none. The first layer was only half filled when I checked and I want to know if you guys have any suggestions.

I used the base preset for generic TPU.

This is the first layer I get after trying a couple different presets. Better than before but still horrible.

you are viewing a single comment's thread
view the rest of the comments
[–] 2 points 10 months ago (1 child)

Maybe try with these settings (found elsewhere) : https://imgur.com/a/vGV9DV0

It seems like it's the default TPU settings with these tweaks :

  • Pressure advance to 0.018
  • Density to 1.111
  • Max volumetric speed to 2
  • permalink
  • fedilink
  • source
  • hideshow 1 child comment
    •