you are viewing a single comment's thread
view the rest of the comments
[–] 11 points 2 years ago (3 children)

No, it was really a technical issue. Analog signals are very prone to noise, and noise is cumulative. Even the best recording heads are going to pick up stray magnetic fields, and of course you get the typical cosmic ray noise hitting the recording tape and head, and then there's noise in power lines that also contribute to the noise.

Basically, what you don't get to hear anymore causes it: Tune an older radio to somewhere between stations. The static exists all the time. If it didn't, it would just be no noise at all, rather than static. Same with older, analog TVs: You see snow and hear static. That's all environmental noise, which will impact analog recording medium. Even the source side of the house gets that noise introduced. That's what Signal-to-noise ratio means: How much signal, vs how much noise exists.

So, dupe of a dupe of a dupe... All recording noise.

  • source
  • parent
  • hideshow 3 child comments
  • [–] 2 points 2 years ago

    It's also quality of the tape and how we used it. You could buy a tape and use it for 2, 4, or 6 hours with a tradeoff in quality. Blank tapes were rather expensive, so we all used 6 hours and then copied from there.

    Commercially produced VHS tapes also tended to be higher quality than blank tapes, unless you went out of your way to buy the quality ones.

  • source
  • parent
  • [–] 1 point 2 years ago (1 child)

    And it still happens even with digital technology. If you, say, rotate a .jpg file a few thousand times, the image will start to degrade as it doesn't perfectly copy over everything and the very slight losses start to add up.

  • source
  • parent
  • hideshow 1 child comment