neal33

I had a similar issue when I initially installed Klipper on my Ender 3 S1 (not the plus). It would not connect unless I fully restarted Octoprint whenever I turned on the printer. The change I needed to make was go into settings in Octoprint (though I assume its similar on other front ends), and add the following settings:
Serial Port: /tmp/printer
Baud Rate: 11520

If that is not the case for you, try to add some more details. Do you have the config file correct?

.05 on my ender 3 s1 sounds perfect based on the tolerance tests I've run. Thanks!

Thats a very fair point. I've done tolerance tests with mine and can get away with 0 with some encouragement and .05 just fine. Thanks!

Just curious, when making this how much tolerance did you account for? I want to make some for baseball teams, but wasn't sure how much to add.

Shouldnt be the filament then. I would make sure the probe is fully secured like the other comment suggested. Good luck, that sounds frustrating! I need to adjust mine, but usually after printing for a couple weeks.

What type of material are you printing? Could be the material is eating away at the brass nozzle causing you to need to adjust the z offset.

Similar results with my Ender 3 S1. Highly recommend!

A hair away from a game 5 😔

I hate how much this reminds me of the 90s. Best offense in baseball to first round exit. It stings now. And unfortunately overshadows an amazing season. 40/70, Olson's records, tying the all time home run, Strider and his strike out pace. Ugh!

Well that sucked. Need to win game 2 on Monday.

Magic number is 2
Olson hit 51 and tied the Atlanta record
Acuña is getting even closer to 40-70
What a season!

Oh dang, I misread another comment you made. With regular stain the longer you leave on usually the darker it just makes it appear. But as long as you fully wiped off the excess after it should have worked out. That said I've only used stain on actual wood. Haven't tried printing wood PLA yet.