this post was submitted on 25 Jun 2024
343 points (91.3% liked)
3DPrinting
15661 readers
184 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I have the opposite problem, my prints stick to the bed too well, I can hardly get them off!
Let the bed cool down all the way, ya little gremlin! If you absolutely can't wait, put the bed on a tile floor and your print should pop off on it's own pretty quick.
I do! Lol I've had a print stuck to my bed for the last 2 weeks.
If it is a removable bed, pop that bad boy in the freezer for a bit and the print should pop off. If not then you may want to try some glue stick on the bed before a print which will help the print release since it'll pull off the glue.
It is, but muh freezer's full of food and it is glue sticked lol.
Damn that's wild, what type of bed is it?
Ender 5 glass bed.
When a print is really stuck, I use a puddy knife with a fine edge and a hammer to get them separated.
🤣
I don't want to scratch the glass or I would.
This is a glass bed on an Ender that I am doing this on. I haven't had any issues with scratching the bed whatsoever. Mild steel is actually softer than glass so it might actually be harder to scratch than you might think. Your mileage may vary though.
Huh, well, that's what I'm on too so I guess maybe it'll work out lol
God speed, lol.
FWIW I exclusively use PLA and don't have experience with any other materials.
Same but PLA+ lol
Chuck the bed in the fridge for 1-2 mins
I'll give that a shot, thanks.